How to connect our PIR sensor to your camera wirelessly

Please start by watching the video about our wirelessly triggers. From 4 minutes, you can see how the wireless triggers can be used to connect the PIR to a camera wirelessly.
http://www.camtraptions.com/camera-trapping/wireless-triggers/

You will need a Canon E3 cable to connect the sensor to the wireless transmitter:
http://store.camtraptions.com/collections/camera-traps/products/camera-connecting-cables?variant=1095192871

You will then need a wireless trigger kit, with a connecting cable for your camera:
http://store.camtraptions.com/collections/camera-traps/products/wireless-trigger?variant=1264022723

On your PIR sensor, you will need to set switch 6 to ON so that it sends a signal that is compatible with the wireless triggers.

If you would like to wirelessly trigger flashes at the same time then you will need another transmitter connected to the camera's hotshoe and set to a different channel to the sensor transmitter. You will then need receivers for each flash set to the same channel as the hotshoe transmitter. This will ensure the flashes are synchronised with the camera shutter.